Xh-m608 Manual Jun 2026

The module is primarily used for two types of battery management, which can be selected via the control interface:

Employs a relay output to simplify the control of external chargers or loads. Programming Guide (Menu P0–P4) The module is programmed using three buttons: . To enter the settings, long-press Description Operating Mode Sets the module to (Voltage detection), (Charge mode), (Discharge mode), or (Voltage limit/monitoring). Lower Limit Voltage Xh-m608 Manual

| Issue | Why the manual fails | |------------------------------------|--------------------------------------------------| | Wrong sensor type | Manual says “NTC 10K” but not B-value (3435 vs 3950). | | Relay does not turn off at setpoint | Manual doesn’t explain that cooling vs heating logic inverts hysteresis. | | Display shows “---” or “HHH” | Manual lacks detailed error code list. | | Buttons don’t respond | Manual doesn’t mention entering programming mode (hold Set 3+ sec). | | Power supply confusion | Some units accept DC 12–24V, others only 12V – not specified. | The module is primarily used for two types

Charge control, discharge control, timing discharge, and voltage calibration. Physical: Approximately 66 x 46 x 16 mm; Weight ~80g. 2. Wiring and Setup Lower Limit Voltage | Issue | Why the