Sky 32 Vi Driver Direct

: You can connect via "Station mode wifi" by entering the device's IP address into your slicer or cutting software. : For offline "paper creation," save your files as files on a USB stick formatted to 4. Hardware Calibration for Paper To ensure the paper is "created" (cut) accurately: C SERIES CUTTING PLOTTER

[Sensor Layer] ├── 16x Imaging Radar (4D) ├── 8x LiDAR (solid-state, 905 nm) ├── 4x High-res optical (8MP, HDR) ├── 2x Long-wave IR thermal ├── 2x Ultrasonic close-range arrays │ ▼ [Fusion & Perception] – Vi NPU (30 TOPS) │ ▼ [Path Planning] – Hierarchical (Route + Local + Reactive) │ ▼ [Control Interface] – CAN-FD / Ethernet AVB │ ▼ [Actuator Commands] – Steering, Brake, Throttle, Gear, Signals Sky 32 Vi Driver

: If the machine is not recognized, check your system's USB report (e.g., System Report on Mac). It should appear as SKY32VI . Connecting your SkyCut Machine via USB (SCAL) : You can connect via "Station mode wifi"

: Automatically searches for and processes registration marks for high-precision cuts. It should appear as SKY32VI