Tait Tm8200 Programming Software !!install!! Jun 2026

| Item | Part Number / Spec | Purpose | |------|--------------------|---------| | Programming cable | (USB) or CA-019208-001 (RS232) | Connects radio DB15 accessory port to PC. | | USB driver | Silicon Labs CP210x (for newer USB cables) | Allows PC to see the radio as a COM port. | | Power supply | 13.8V DC, 5A minimum | Radio must be powered on during programming. |

Navigate to the menu. Here you can add entries to the channel table. Ensure you are entering the correct offsets for repeaters and selecting the proper CTCSS or DCS tones to ensure you can "trip" the repeater or filter out unwanted interference. 4. Customizing UI and Buttons tait tm8200 programming software

Most versions of the Tait TM8000 series software run on Windows 7, 10, or 11. You may need to install specific USB-to-Serial drivers (often Prolific or FTDI) for your cable to be recognized as a COM port. Step-by-Step: Programming Your TM8200 1. Initial Connection | Item | Part Number / Spec |

Define RX/TX frequencies, bandwidth, and power levels. | Navigate to the menu

Always use the software version that matches the radio’s firmware vintage. If your TM8200 was built before 2015, stick with TPCS v1.6–v1.9. For radios with firmware r2.20 or higher, use Tait Configuration Manager v5.x.