Diagbox 7.02 -plus 7.57- Vmware - Mhh Auto - Page 1 →

Connect the Lexia interface via USB and ensure it is "connected to the VM."

By following these general steps, you should be able to set up Diagbox 7.02 and 7.57 on a VMWARE virtual machine with MHH AUTO resources. If you encounter issues, refer to the official documentation and forums for more detailed assistance. Diagbox 7.02 -plus 7.57- VMWARE - MHH AUTO - Page 1

: Versions like 7.02 and 7.57 are essential for older Peugeot and Citroën models that may not be fully supported by newer "standalone" versions. Connect the Lexia interface via USB and ensure

| Error Message | Likely Cause | MHH Fix | | :--- | :--- | :--- | | | Wrong COM port assigned in VMWare. | Set USB compatibility to USB 2.0 (not 3.0) in VM settings. | | "Diagbox is locked" | System date tampered or clone detected. | Restore from VM Snapshot taken before the error. Never run Diagbox with your PC date set in the future. | | "No dialog with ECU" | Version 7.57 is too high for a 2004 car. | Use the "Lexia" interface in Diagbox settings to downgrade temporarily. Or, keep a second VM with only 7.02 for old cars. | | "The global configuration is corrupt" | BSI communication error. | Check your car's battery voltage. Diagbox is highly sensitive. Charge the battery first. | | Error Message | Likely Cause | MHH

Nice share. Just a heads up – your 7.44 update step is unnecessary if you use the “direct to 7.57” patched updater from (posted last month in the VIP section). Saves about 20 minutes of install time.